ESP CanCam User Manual page 13

CanCam Manual_Layout 5 05/09/2013 12:22 Page 13
Program CanCam using CAM mode
Setting the CAM Operation Mode:
The CanCam can be programmed to operation either in PIR Detection mode or
Time Lapse / PIR mode.
• Slide the switch to the CAM position.
• LCD display will show the camera status screen.
• Press the [M] button once within 30 seconds to enter the programming mode,
the word PIR or TLS will be blinking.
• Press the [UP] or [DN] button to select PIR mode.
• Press [OK] to save your selection.
• Press [M] button to exit.
Setting the Image Resolution in PIR mode:
The CanCam can be programmed to 3 different image resolutions: 3 Stars is 8Mp,
2 Stars is 5Mp and 1 Star is 3Mp.
• Slide the switch to the CAM position, LCD display will show the camera status
screen.
• Press the [M] button once within 30 seconds to enter the programming mode.
• The word PIR will be blinking, press [OK] to confirm the camera's operation is
PIR detection.
• Press [UP] or [DN] button until the word CAM is blinking.
• Press the [OK] button ONCE to confirm the camera into CAM mode, the STARTS
will be blinking.
• Press the [UP] or [DN] button to select the desired resolution.
• Press [OK] to save your selection, then current number of burst shoot will
blinking. Press [OK] to enter the burst shoot setting or press [M] button to exit.
Setting the Image burst shoot in PIR mode:
The CanCam can be programmed to shoot 1-9 pictures per triggering.
• Slide the switch to the CAM position, LCD display will show the camera status
screen.
• Press the [M] button once within 30 seconds to enter the programming mode.
• The word PIR will be blinking, press [OK] to confirm the camera's operation is
PIR detection.
• Press [UP] or [DN] button until the word CAM is blinking.
• Press [OK] button ONCE to confirm camera into CAM mode.
• Press [UP] button ONCE to enter burst shoot setting, the current number of
burst shoot will blink.
13