ESP CanCam User Manual page 14

CanCam Manual_Layout 5 05/09/2013 12:22 Page 14
• Press [OK] then press the [UP] or [DN] button to select the desired burst mode
setting or number of pictures per triggering.
• Press [OK] to save your selection, then the time out T-O will blinking. Press
[OK] button to enter time out setting or press [M] button to exit.
Setting the Video Resolution in PIR mode:
The CanCam can be programmed to 2 different video resolutions: 2 Stars is HD
720, 1 Star is VGA 640 x 480 pixels.
• Slide the switch to the CAM position, LCD display will show the camera status
screen.
• Press the [M] button once within 30 seconds to enter the programming mode.
• The word PIR will be blinking, press [OK] to confirm the camera's operation is
PIR detection.
• Press [UP] or [DN] button until the word VIDEO is blinking.
• Press the [OK] button ONCE to confirm the camera in VIDEO mode, the STARS
will be blinking.
• Press the [UP] or [DN] button to select the desired resolution.
• Press [OK] to save your selection, then current number of video length will
blinking. Press [OK] button to enter video length setting or press [M] to exit.
Setting the Video length in PIR mode:
TheCanCam can be programmed to record 5-300 seconds of video per triggering.
The Video mode is only workable under PIR mode.
• Slide the switch to the CAM position, LCD display will show the camera status
screen.
• Press the [M] button once within 30 seconds to enter the programming mode.
• The word PIR will be blinking, press [OK] to confirm the camera's operation is
PIR detection.
• Press [UP] or [DN] button until the word VIDEO is blinking.
• Press the [OK] button ONCE to confirm the camera in VIDEO mode.
• Press [UP] button ONCE and the video length in seconds will be blinking.
• Press [UP] or [DN] button to select the desired video length from 5 to 300
seconds in 5-second increments.
• Press [OK] to save your selection then the time out T-O will blinking. Press [OK]
button to enter time out setting or press [M] button to exit.
14