Midi Settings For V-Link; Midi Message Settings For Detailed Performance Expression [F3 (Ctrl)] - Roland V-Drums TD-20X Owner's Manual

Chapter 10. MIDI Settings

MIDI Settings for V-LINK

V-LINK MIDI Ch (V-LINK MIDI Channel)
When V-LINK function (p. 123) is on, the performance data
recorded in the backing part of the sequencer is transmitted
on this channel.
At the factory settings, this is set to "CH16."
V-LINK Device ID
Set this ID to match the device ID number of the device
which is controlled by the TD-20X. If this is set to "128," you
can control the device regardless of the device ID number of
it.
At the factory settings, this is set to "128."
MIDI Message Settings for
Detailed Performance
Expression [F3 (CTRL)]
1.
Press the [SETUP] button.
The [SETUP] button lights, and the "SETUP" screen appears.
2.
Press the [F1 (MIDI)] button.
3.
Press the [F3 (CTRL)] button.
The "MIDI CONTROL" screen appears.
fig.10-003-midi-ctrl.eps_70
4.
Use the [CURSOR (up/down)] buttons to select the
parameter.
118
5.
Use the [-] [+] buttons or the [VALUE] dial to make
settings.
Parameter Value
OFF,
Pedal CC
MODULATION(1),
BREATH(2),
FOOT(4),
Snare CC
EXPRESSION(11),
GENERAL1(16)–
Ride CC
GENERAL4(19)
Toms CC
HH Note#
0–127
Border
When a control change is set to be more than one
parameter, an asterisk (*) appears at the right of the
unavailable parameter.
6.
Press the [EXIT] button twice to return to the
"DRUM KIT" screen.
Description
Control change used for
transmitting/receiving the
depth to which the hi-hat
pedal pressed
Control change used for
transmitting/receiving the
strike position of the snare,
ride, and tom 1–4
The only time you would
need to change this setting
is when you are triggering
an external sound module.
The note number
transmitted when you strike
the hi-hat will change
depending on the amount of
pressure on the hi-hat pedal.
Hi-Hat Note Number Border
allows you to adjust the
pedal position at which the
note number switches from
the open hi-hat to the closed
hi-hat.
At the factory default value
(127), the closed hi-hat note
number will be transmitted
only if the hi-hat pad is
played with the pedal
completely depressed. If you
want this note number to be
transmitted when the pedal
is slightly raised, set this to a
value such as 90.
If you change the hi-hat note
number border setting, the
actual hi-hat performance
may not match the playback
of the recorded pattern.