Settings For Separate Triggering Of Ride Strikes [F3 (3-Way)]; Strike Position Detection On/Off [F4 (Posi)] - Roland V-Drums TD-20X Owner's Manual

Settings for Separate Triggering of Ride
Strikes [F3 (3-WAY)]
fig.08-018-3way.eps_70
Parameter Value
3Way Trigger
OFF, ON
(Ride & Edge)
Playing bow, bell, and edge (3Way Triggering)
When using the CY-15R or CY-12R/C for the RIDE, you can
three way triggering (bow, bell, and edge shot) performance
are possible.
3Way Trigger: OFF, ON
Connect as shown in page 21, set 3Way Trigger to "ON."
Correspondences between playing method and
trigger input
Playing Method
Bow Shot
Bell Shot
Edge Shot
Head-side tone for the trigger input 11 EDGE cannot be
sounded.
When "3Way Trigger" is set to "ON," "RD CTRL" is
displayed for the trigger type for trigger input 11 EDGE.
It cannot be changed (p. 96).
Description
Enable/disable separate
triggering of bow/bell/edge
strikes on the ride cymbal
TD-20X TRIGGER INPUT
10 RIDE head
10 RIDE rim
11 EDGE rim
Chapter 8. Trigger Settings for Each Pad [TRIGGER]
Strike Position Detection On/Off
[F4 (POSI)]
For the pads listed below, strike position detection (p. 34) can
be turned on/off.
If you turn strike position detection on, you'll be able to
produce tonal change by varying the strike position on the
head or by changing the nuance of your rim shots.
Pads that can detect the strike position
• 2 SNARE (head/rim)
• 3–6 TOM 1–4 (rim)
• 10 RIDE (bow)
• 12–15 AUX 1–4 (rim)
If you select a "Trig Type" that does not support
positional sensing, the value will be shown as "- - -", and
you won't be able to edit the setting.
fig.08-019-posi.eps_70
Parameter Value
Trig Type See p. 96.
Position Detect
Head
ON, OFF
Rim
Description
Positional sensing
on/off
105