Roland V-Drums TD-20X Owner's Manual page 120

Chapter 10. MIDI Settings
5.
Use the [VALUE] dial, the [-] [+], and [CURSOR (up/
down)] buttons to select the content to be sent.
Transmit Data
ALL
SETUP
ALL DRUM KITS
1 DRUM KIT
ALL TRIG BANKS
1 TRIG BANK
ALL PERC GROUPS
1 PERC GROUP
ALL PATTERNS
6.
Start the recording process of the external
sequencer.
7.
Press the [F5 (EXECUTE)] button to begin sending
the data.
If you want to stop sending, press the [F1 (STOP)] button.
fig.10-007-bulk55.eps_70
8.
When finished, the following screen appears.
fig.10-008-bulk-comp.eps_70
9.
Press [EXIT)] button to return to the previous
screen.
Bulk Dump is one kind of System Exclusive message. Be
sure to use an external MIDI sequencer that is capable of
recording System Exclusive messages. In addition,
confirm that the sequencer is not set to "Do not receive
System Exclusive messages."
120
Description
All data, including setup, drum kits, user
percussion sets, user patterns
Trigger, pad, and other kinds of settings
All data for drum kits 1–100
Only the data for the selected drum kit
All settings for trigger banks 1–4
Only the settings for the selected trigger
bank
All data for the user percussion sets 1–8
Only the data for the selected percussion
set
All data for the user patterns 151–250
Loading data to the TD-20X
At this time, all the TD-20X's current data is overwritten.
Make sure you have made the needed backup.
1.
Connect the TD-20X's MIDI IN connector with a
MIDI cable to the MIDI OUT connector of the
external sequencer.
fig.BulkLoad.e
MIDI OUT
Sequencer
2.
Get your external sequencer to start sending the
settings data that was previously bulk dumped to
it.
Received data is written into the TD-20X.
MIDI IN
TD-20X