To Enable Or Disable A Device - Honeywell System 800 Operator's Manual

To enable or disable
a device
A2
Select Select
Press select to change to a
required device number
Previous Previous
Press to select [Status] field
28
796689 (4188-658) i2_04/07
A device such as a detector or manual call
point can be disabled or enabled. This may be
necessary during maintenance work on the
system. On completion of maintenance work
the device must be re-enabled.
Enter access level 2 (A2) and use the
navigation buttons to highlight and
select options:
This operation will allow disablement
and enablement of devices like
detectors and manual call points
on the loop.
Next Next
Select Select
Press select to toggle ENABLE/DISABLE
Select DISABLE to disable the device
or ENABLE to enable the device
Previous
Press to select [Device] field
Next