Minolta EPI 054 User Manual page 99

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 MECHANICAL/ELECTRICAL
98.04.24
6. Paper Feeding
Paper is fed either automatically from the 1st or 2nd Drawer, or manually via the Multi
Bypass Table or Manual Bypass Table. Each Drawer has fingers that function to separate
the top sheet of paper from the rest at take-up. (2nd Drawer: 23 cpm Copier Only)
(For more details, see "13. PAPER TAKE-UP/FEED SECTION".)
7. Image Transfer
The single-wire Image Transfer Corona Unit applies a DC negative corona emission to the
underside of the paper, thereby attracting toner onto the surface of the paper.
(For more details, see "16. IMAGE TRANSFER AND PAPER SEPARATION".)
8. Paper Separation
The single-wire Paper Separator Corona Unit applies an AC corona emission to the
underside of the paper to neutralize the paper. In addition, mechanical paper separation is
provided by the two PC Drum Paper Separator Fingers fitted to the Imaging Unit.
(For more details, see "16. IMAGE TRANSFER AND PAPER SEPARATION".)
9. Cleaning
Residual toner on the surface of the PC Drum is scraped off by the Cleaning Blade.
(For more details, see "19. CLEANING UNIT".)
10. Main Erase
Light from the Main Erase Lamp neutralizes any surface potential remaining on the sur-
face of the PC Drum after cleaning.
(For more details, see "17. MAIN ERASE LAMP".)
11. Transport
The paper is fed to the Fusing Unit by the Suction Belts.
(For more details, see "20. PAPER TRANSPORT".)
12. Fusing
The developed image is permanently fused to the paper by a combination of heat and
pressure applied by the Upper and Lower Fusing Rollers.
(For more details, see "21. FUSING UNIT".)
13. Paper Exit
After the fusing process the paper is fed out by the Paper Exit Roller onto the Copy Tray.
(For more details, see "22. EXIT UNIT".)
M-5