Minolta EPI 054 User Manual page 84

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
Reduction
1139D042AA
1139D032CA
1151D040AA
1151D041AA
1139D019CA
1. After the leading edge registration in an enlarge-
ment mode has been adjusted, make two single
copies in a reduction mode (50%) and check for
leading edge registration on the second copy.
2. If the registration does not meet the requirement,
go to the control panel and press the Meter Count
Key, stop Key, 10-keys "0", 10-keys "0", stop Key,
10-keys "0", 10-keys "1", Stop Key, Start Key to set
the copier into the Adjust Mode. (At this time, the
Magnification Ratio Indicator shows "A.")
3. Press 10-keys "5" and press the Start Key. (Then,
the Magnification Ratio Indicator shows "A 5" and
the Multi-Copy Display, the current setting value.)
4. Press the Clear Key to clear the current setting
value.
5. With the old setting value used as reference, enter
the new setting value using the appropriate 10-
keys.
NOTE
If dimension A on the copy is smaller than 8.5 mm,
decrease the setting value.
If dimension A on the copy is greater than 11.5 mm,
increase the setting value.
6. Press the Start Key to validate the new setting.
7. Press the Panel Reset Key twice (or turn OFF the
Power Switch) to return the copier back to the nor-
mal mode.
8. Make two single copies and check for leading edge
registration on the second copy. (If it does not meet
the requirement, perform steps 2 through 9 again.)
D-65