Dimensions; Mounting; Attachment; Installing The Optional Plug-In Module - Mitsubishi Electric ME96NSR Operator's Manual

Electronic multi-measuring instrument ns series

Hide thumbs Also See for ME96NSR:

User manual (70 pages)

Table Of Contents

Table of Contents

Dimensions

, R

95.8 (COVER)

91.6 (PANEL CUT)

Mounting

1 Dimensions of Panel

The panel hole dimensions are shown below.

It can be attached to a panel with thickness of 1.6 to 4.0mm.

+ 0.5

3 Attachment

For attachment of the basic device into the panel hole, attach according to the following procedure.

①The attachment lug is installed in two holes

of the top and bottom of the basic device.

4 Installing the Optional Plug-in Module

When installing the optional plug-in module onto the basic device, install according to the following procedure.

①The option cover is removed.

A protective sheet is attached to the display for protection against scratch during the attachment to panel. Before using, remove the protective sheet.

When you remove it, the display may light up due to generation of static electricity, but it is not an error. It goes off by natural discharge after a while.

Note

In the case to attaching to the end of the panel, check the wiring work space and decide the attachment position.

Install the optional plug-in module after the power is turned off.

The option is not recognized when installed while power is on.

In this case, the option is recognized by power suspension/power resumption or restarting the basic device.

(With the optional plug-in module)

2 View Angle

The contrast of the display changes at view angles.

Mount it at the position that is easy to see.

②Tighten the screws of the lug, and fix onto the panel.

②The optional plug-in module is installed.

Combine the slot of the basic device and the