Advertisement
External Dimensions/Installation/Connections
Dimensions
ME96SSH-MB, ME96SSR-MB
91.6 （PANEL CUT）
ME96SSE-MB
Mounting
1 Dimension of panel
Panel hole dimensions are as shown in the following figure.
It can be attached to a panel with thickness of 1.6 to 4.0mm.
+ 0.5
92
0
3 Attachment
For attachment of the basic device into the panel hole, attach according to the following procedure.
qThe attachment lug is installed in two holes of the top and bottom of the basic device. wTighten the screws of the lug, and fix onto the panel.
4 Installing Optional Plug-in Module
When installing the optional plug-in module onto the basic device, install accoroding to the following procedure.
qRemove the optional cover.
25
(when optional unit is attached)
91.6 （PANEL CUT）
95.8 （COVER）
2 View Angle
The contrast of the display changes at view angle. Mount it at the position that is
easy to see.
Viewing angle
10°
60°
To prevent damage to the panel and screws, do not fasten screws
too tightly.
Note
Recommended torque for these products: 0.3~0.5N·m (approx. half
of standard torque)
Also, please tighten the upper and lower screws at the same time.
Main unit mounting screws: M3
wAttach the optional
unit to the main unit.
Optional Plug-in Module
(side view)
(overhead view)
91.6 （PANEL CUT）
Optional cover
95.8 （COVER）
88.8
81.2
25.2
46.8
17.1
Fit the protruding part of the optional unit into
the slot in the main unit.
Advertisement
