Re-Assembling the DynaKey
24. Remove the Keylock by prying the Retaining Clip off with a small
screwdriver.
25. The LED Board can be removed by prying off the Tinnerman Clip.
Replacing the Keylock assembly
1. Align the tabs and snap into place.
2. Carefully route the wires through the bezel.
To re‐assemble the DynaKey module, use the reverse order of the
previous procedures. In addition, check the following:
1. Before closing the cabinet, check the LCD to make sure there are no
fingerprints or lint particles on it.
2. Make sure the cables are routed properly before closing the cabinet.
Chapter 6: Hardware Service 6-19
Keylock Retaining Clip
Tinnerman Clip
19925