3-10 Chapter 3: Hardware Installation
Connecting to the Host Terminal
Powering Up
The 5953 connects to the host terminal via two cables.
•
Digital Video Interface (DVI) cable for video
•
Powered Universal Serial Bus (USB) for data and power
This section describes how to power up the system and the initial
checkout procedures after all hardware has been installed.
1. Plug the terminal AC Power Cord into an AC power source.
2. Turn the Keylock on the DynaKey to the Ex position.
3. Power on the system.
Special Keypad Mode
The BIOS setup routine requires keys that are not present in the regular
DynaKey keypad layout (such as the ESC and End keys). Although the
DynaKey has a PC keyboard port, a PC keyboard may not be readily
available to the operator. To use the DynaKey to run setup routines,
you can place the DynaKey into a special alternate layout mode that
replaces the normal layout of the keypad and function keys. To enter
the special Setup Keypad Mode, proceed as follows:
1. Power up the system.