Chapter 3: Hardware Installation; Introduction; Sensormatic Restriction - NCR RealPOS 5953 User Manual

Chapter 3:

Introduction

Sensormatic Restriction

Hardware Installation
Caution: This device should only be powered by a power supply
source which meets Safety Extra Low Voltage (SELV) and LPS (Limited
Power Source) requirements per UL1950, IEC 950, and EN 60 950. The
power source must be certified by the appropriate safety agency for the
country of installation.
Caution: Use a grounding strap when installing this feature.
The DynaKey is fully assembled at the factory. This section describes:
•
Serial number locations
•
Cable Connector Access
•
Mounting Options
•
Installing a USB DynaKey
•
Installing an Integrated Customer Display
•
Powering Up
•
Screen Saving Features
Avoid placing the DynaKey within 12 inches of a Sensormatic tag
detection device.