Tv Signal Amplifier; Cable Tv And Satellite Hook-Ups - Winnebago Destination Manual Manual

CAUTION
Always align directional handle to
"DOWN" position before lowering.
Never partially raise or lower antenna.
Antenna must be raised fully up into
operating position or lowered fully down
into travel position.

TV SIGNAL AMPLIFIER

The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch on the video selection system in the video
center cabinet above the driver and passenger
seats or entertainment center cabinet.
A red indicator light will glow when the
switch is on and the signal amplifier is active.
TV Signal Amplifier Switch on
Video Selection System
(Typical View)
Push On-Off
TV Signal Amplifier Switch
(Typical View)
-Model M39N shown
Checking Amplifier Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter (tower). Signals may vary from
strong to no usable signal at all. We recommend
that the TV system be checked out in an area
known to have good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
CABLE TV AND SATELLITE
HOOK-UPS
(Input)
The cable television and portable satellite dish
input connectors are located in the utility
compartment.
The input lines can be routed through the
hatch in the bottom of the compartment so the
door can remain shut while connected.
SECTION 8 –
ENTERTAINMENT
8-9