Windshield Washers And Wipers; Tires; Suspension Alignment And Tire Balance - Winnebago Destination Manual Manual

Fuse Diagram (inside of cover)
- Diesel
Further Information
See your chassis manual in your InfoCase for
further information about chassis supplied fuses
and relays.
WINDSHIELD WASHERS AND
WIPERS
The windshield washer fluid reservoir is
located in the front of the coach behind the
"hood" panel. A long-necked funnel may be
required for filling.
We recommend using commercially available
premixed solutions for best results. Do not use
water in freezing temperatures because the
washer pump could become damaged.
Windshield Washer Reservoir
(Located behind front hood panel)
DRIVING YOUR MOTOR HOME

TIRES

Improper tire pressure can result in tire
overloading and abnormal wear and also affects
handling, ride characteristics, and fuel economy.
WARNING
Make sure all replacement tires are of the
same size and ply rating as those
installed as original equipment.
Further Information
See your Vehicle Certification Label for tire
information.
SUSPENSION ALIGNMENT
AND TIRE BALANCE
The front suspension and steering system of
this vehicle was factory aligned using highly
accurate equipment prior to delivery to the
dealership. However, alignment should be
checked and adjusted after you have fully loaded
the motor home according to your personal
needs. Thereafter, the alignment should be
periodically inspected to help prevent uneven tire
wear.
Any excessive or abnormal tire wear may
indicate worn or misaligned suspension or
steering, unbalanced tire, or other tire/suspension
problem.
Alignment can be affected by worn steering/
suspension parts or by incidents which happen
during driving, such as hitting a curb, pothole, or
railroad track, etc. Improper alignment can cause
tires to roll at an angle and wear unevenly. It may
also cause the vehicle to "pull" to the right or left.
Have your dealer inspect your vehicle's
suspension and steering components periodically
for misalignment or wear.
Out-of-balance tires will not roll smoothly and
can lead to vibrations and uneven tread wear,
such as cupping and flat spots. Tires may need to
be balanced if uneven wear is detected or if ride
comfort decreases noticeably.
SECTION 3 –
3-21