Systems Monitor Panel - Winnebago Destination Manual Manual

SECTION 4 –
APPLIANCES AND SYSTEMS

SYSTEMS MONITOR PANEL

The Systems Monitor Panel provides a
convenient central location for checking the
condition of all utility systems in your coach.
At the touch of a button this panel will display
the fresh water and holding tank levels, propane
gas tank level, plus the house battery condition.
You can start the generator or turn on the water
pump and water heater. Indicator lights tell you if
the water pump is on or if the water heater pilot
light is out.
Water And Holding Tank Levels
Press and Hold the "Levels Test" switch to
show approximate level on the monitor lights.
The approximate fluid levels are measured by
electronic sensors on the sides of the tanks. There
is generally more fluid in a tank than indicated on
the monitor panel.
4-4
Water Level
Water Tank
For example, if the fluid level is 1-2" below
the FULL sensor, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If a tank is about 1/4 full, the monitor will
register an empty tank because the fluid level is
below the 1/3 sensor even though there is still
fluid in the tank.
However, when the indicator reads FULL, the
tank is actually full.
Gray Waste Tank Selector (Model
39W only)
This model has two gray water tanks. Because
the monitor can display only one gray water tank
at a time, a selector switch is provided.
Press the switch to select the desired gray tank
level to display on the monitor lights.
Tank Capacities
See "Tank Capacities" in Introduction section.
Propane Gas Level
Press and Hold the "Levels Test" switch to
show approximate propane tank level.
Sensors