Tv Antenna - Winnebago Destination Manual Manual

SECTION 8 –
ENTERTAINMENT
600-Watt DC-AC Power Inverter
• Turn Inverter switch On to use inverter power.
• Inverter Power indicator will light when inverter is
operating.
• External Power indicator light will light when
shoreline is plugged in and inverter is not needed.
• Low Input Voltage indicator will light if 12V house
batteries are becoming drained. (Turn Off inverter
to avoid total discharge.)
• Turn inverter off when Overload and High
Temperature warning indicators alert you to
operating cautions.
• Turn Inverter Off when not in use to avoid draining
house batteries.
• The inverter will shut down when the Aux Battery
Disconnect switch is turned off.
*NOTE: Running high-amperage appliances
like the TV and DVD on inverter power
can drain the house battery rapidly
unless the chassis engine is running so
the alternator can charge the batteries.
Further Information
See manufacturer's information provided in
your InfoCase for more information.

TV ANTENNA

The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or directional handle. A built-in signal amplifier
designed to strengthen signals, is controlled by a
power switch built into the optional video
selector panel or on a wall plate assembly.
See the antenna manufacturer's operation,
care and maintenance information in your
InfoCase.
8-8
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Raising Antenna to Operating Position
Turn elevating crank clockwise in "UP"
direction until some resistance to turning is noted
(about 13 turns). Antenna is now in operating
position.
Turn amplifier power switch "ON" to receive TV
signal.
Rotating Antenna for Best Picture
Make sure antenna is in the "UP" position.
Pull down on directional handle using both hands
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counter-clockwise) in
"DOWN" direction until resistance is noted
(about 13 turns). Antenna is now locked in travel
position. Turn amplifier power switch "OFF".