Sofa/Bed Conversion; Rest Easy Multi-Position Lounge - Winnebago Destination Manual Manual

SECTION 9 –
FURNITURE AND SOFTGOODS

SOFA/BED CONVERSION

Sofa to Bed
Lift the front edge of the sofa seat upward and
pull outward from the wall while gently pushing
downward on the backrest until the cushions lie
flat. The bed is now ready for use.
Bed to Sofa
Push the front edge of the seat toward the wall
while lifting upward on the backrest until the sofa
is fully seated against the wall.
REST EASY MULTI-POSITION
®
LOUNGE
–If Equipped
CAUTION
Do not recline the lounge completely flat
unless the footrest section is extended.
To Recline
1. Press the switch on the front of the armrest.
Press "down" to recline; "up" to return
upright.
NOTE: Be sure house batteries contain adequate
charge. If the batteries are partially
discharged, the sofa may not fully recline
or return to the upright position.
9-4
To Extend Pull-Out Footrest
Section
1. Squeeze latch behind opening at top of lounge
face panel and pull footrest trundle section out
until it locks in the fully extended position.
2. Lift footrest up and away from lounge until it
is raised into position.
3. The gap between the footrest and seat should
provide ample room to enter and exit the
lounge. If you wish, however, you can unlatch
the footrest and push it against the lounge seat.