Extending The Dpr-300 Board - Sony HXCU-100 Service Manual

Extending the DPR-300 Board

1. Disconnect the coaxial cable from the con-
nector CN3901 on the DPR-300 board.
(Refer to Section 5-5-6.)
n
Be sure to hold the plug when disconnecting
the coaxial cable. Do not pull the cable.
2. Draw the DPR-300 board out of the chassis.
3. Connect the extended board EX-1098 to the
MB-1124 board.
4. Connect the DPR-300 board to the extended
board EX-1098.
5. Disconnect the coaxial cable from the con-
nector CN5 on the EX-1098 board, and
connect the coaxial cable to the connector
CN3901 on the DPR-300 board.
n
Be sure to hold the plug when disconnecting
the coaxial cable. Do not pull the cable.
6. Connect the coaxial cable (disconnected in
step 1) to the connector CN5 on the EX-1098
board.
HXCU-100
Hold the plug to remove.
OK
Coaxial cable
(Supplied)
CN3901
DPR-300 board
Do not attempt to remove
NG
by pulling the cable.
MB-1124 board
CCU
CN5
Extended board EX-1098
2-9 (E)