Sdi-97 Board - Sony HXCU-100 Service Manual

5-5-12. SDI-97 Board

1. Remove the front assembly.
(Refer to Section 5-1.)
2. Remove the top cover.
(Refer to Section 5-2.)
3. Remove the rear panel assembly.
(Refer to Section 5-3.)
4. Remove the SDI-97 board from the connec-
tor CN1 on the MB-1124 board.
5. Install a new SDI-97 board by reversing the
steps above.
5-5-13. SY-364 Board
1. Remove the front assembly.
(Refer to Section 5-1.)
2. Disconnect the fl exible card wire from the
connector CN1 on the SY-364 board.
n
Be careful not to bend the fl exible card
wire. This shortens the wire life.
3. Open the board lever and draw the SY-364
board.
4. Install a new SY-364 board by reversing the
steps above.
m
. When installing the board, be careful not
to catch the fl exible card wire.
. When the DPR-300 board was removed
and is installed, be careful not to catch
the coaxial cable.
5-14 (E)
MB-1124 board
CN1
Board lever
CN1
Flexible card wire
SDI-97 board
SY-364 board
HXCU-100