Table of Contents
Advertisement
M. INSTALLING RUBBER BUMPERS
M-1 Close the door and apply pressure
making sure the deadlatch (a) rests
on the strike plate (b) as shown.
Standing on the frame (door step)
side of the door, check for gaps between the door and the frame on the
three sides of the frame (left, right and top).
M-2 Mark locations where the gaps are approximately
3
⁄
" (5 mm). Make sure these locations are free from grease and dust. Peel
16
the bumpers (c) (supplied) from their protective backing without touching
the adhesive surface and stick them on the marked locations.
Note: Allow 24 hours for bumper adhesive
to set before testing. The door may be
operated manually during this time.
22
Correct
Incorrect
c
a
b
a
b
Hide quick links:
Advertisement
Table of Contents
