Table of Contents
Advertisement
Leica mojo3D, mojo3D Enhancements
A.6.4
Before installation
mojoXact installa-
tion
Leica mojoXact Installation
Before installing the Leica mojoXact, you must do the following. For more informa-
tion on each of these important steps, please refer to the installation hints specific
to your vehicle or Leica Steer Ready Kit. These installation hints are at
www.virtualwrench.com, How to Guides.
1. Refer to any available installation hints specific to your tractor type.
This information may be available from the web site at www.virtualwrench.com,
or may have been supplied with your system. The method of completion of the
following tasks will be determined by the make and model of your vehicle.
2. Check or prepare for mojoXact power connection.
Verify that you have a mojoXact port expansion cable and a mojo3D port expan-
sion cable available.
3. Install steering cable (CAN bus).
There are many possible combinations for this step, depending on vehicle type,
or Leica Steer Ready Kit used, or both. The cable specific to your vehicle should
be purchased with your system.
Use caution with metal work; it may be sharp and could cause injury if care
is not taken.
1. Carefully remove the mojoXact from its packaging. The mojoXact can be mounted
in any direction. There is no need to mount it exactly flat. The mojoXact should
248
Advertisement
Table of Contents
