Leica mojo3D User Manual page 218

Leica mojo3D, mojo3D Enhancements
Install Cables
1. Connect the Port Expansion Cable to the mojo3D.
2. Connect the Twist to the Port Expansion Cable.
3. Connect the QuickSteer Bus Cable to the Twist.
4. Connect the two connectors on the QuickSteer cable to the QuickSteer bus cable.
5. Connect the bus power cable to a clean 12 volt power source and to the Quick-
Steer cable.

If a multi section control kit is installed, then the QuickSteer bus cable must
be connected to the AS400 bus cable.
mojo3D_013
218