Web Page Conventions And Icons & Buttons - Obihai OBi110 Administration Manual

Web Page Conventions and Icons & Buttons:
Icon / Button Description
This icon indicates that there is more information
available which might describe the workings,
limits or thresholds for the parameter to which it
is adjacent. You can mouse over this icon to
reveal this information.
When a modification has been made to a
parameter on a page, the Submit button MUST
be clicked before proceeding to another page.
If you make changes to a parameter on a page
and you do not want to keep them for
submission, click the "Clear Changes" button to
revert back to the parameter setting present
before the most recent change was entered.
Click the "Use Defaults Only" button if you want
to revert all parameters on a given page to their
Default settings. If you want to revert just one or
two parameters on a page to default settings you
should use the Default check box found on the
right side of the parameter. See next Item.
When you wish to modify a parameter away from
its default setting, you should un-check the
'Default' box. This will open the parameter field
for access and modification. If there is a non-
default setting in a parameter field and you want
to revert that parameter back to its default
setting, check the "Default" box and the default
setting will appear.
This icon indicates that the configuration
currently programmed on the OBi device is "set"
and "running". No reboot is necessary if you
have submitted configuration modifications.
After Submitting changes to a web page on the
OBi, the "Reboot Required" icon may appear. In
order for the modifications to run, you will need
to reboot the OBi.
The "Reboot" button is used when the "Reboot
Required" icon appears indicating the OBi device
requires a reboot to invoke one or more
parameter modifications.
Copyright 2010-2012 Obihai Technology, Inc.
Remark
You will be prompted to
confirm that you want all the
parameters on the page to
revert back to system
default settings.
Default value of a parameter
may be changed with a
firmware upgrade. Leaving a
parameter at default setting
allows the device to use
proper default value with
the firmware currently
installed in the device
This icon does not indicate
the currently running
configuration is working
properly.
You can continue to make
modifications to OBi
parameters – on separate
pages if necessary – before
you reboot and "set" the
modifications in the running
system.
When performing a System
Configuration Reset, the
Reboot button does not
need to be pressed. The OBi
will reboot automatically
when the "Reset" button is
selected.
40