Obihai OBi110 Administration Manual page 105

MWIEnable
3
MWIEnable2
X_VMWIEnable
3
X_VMWIEnable2
MessageWaiting
AnonymousCallBlockEnable
AnonymousCallEnable
DoNotDisturbEnable
X_BridgedOutboundCallMaxDuration
X_AcceptDialogSubscription
X_AcceptLinePortStatusSubscription
X_SkipCallScreening
X_SRTP
Note: 1 ring is approximately 6s
Enable Message Waiting Indication Service for this service. If
enabled, device plays stutter dial tone on the PHONE port (or
PHONE1 port) when there are new messages for the subscriber.
It will also turn on VMWI signal on the PHONE port (or PHONE1
ort) if X_VMWIEnable is set to Yes
Enable Message Waiting Indication Service for this service. If
enabled, device plays stutter dial tone on the PHONE2 port when
there are new messages for the subscriber. It will also turn on
VMWI signal on the PHONE2 port if X_VMWIEnable is set to Yes
Enable Visual Message Waiting Indication for this service for the
PHONE port (or PHONE1 port)
Enable Visual Message Waiting Indication for this service for the
PHONE2 port
This is a state rather than a configuration parameter, that
indicates if there are any new messages for this subscriber on
the service provider's voicemail system
Enable blocking of Anonymous Calls on this service. Anonymous
calls are rejected with a SIP 486 (Busy) response and Call
Forward On Busy service is not applied.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Enable masking of Caller-ID information for all outgoing calls. If
enabled, the called party should perceive the call as coming from
an anonymous caller.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Enable Do Not Disturb Service. If enabled, all incoming calls on
this service are treated as if the device is busy.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Limit on the call duration in seconds for all outbound calls that
are bridged from the same or another trunk. A blank or 0 value
implies the call duration is not limited.
Enable the device to accept SUBSCRIBE to this trunk's dialog
event package
Enable the device to accept SUBSCRIBE to the LINE port status
Enable the device to automatically skip call screening when the
underlying ITSP is Google Voice
This is a drop down list with 3 choices:
- Disable SRTP = Do not use SRTP for all calls; the call will
fail if the peer insists on using SRTP only
- Use SRTP Only = Require all calls to use SRTP; the call
will fail if the peer does not support SRTP
- Use SRTP When Possible = Use SRTP for a call if the peer
supports SRTP; otherwise fallback to use regular
unencrypted SRTP
Copyright 2010-2012 Obihai Technology, Inc.
No
No
No
No
No
No
No
No
FALSE
FALSE
FALSE
Disable SRTP
105