Obihai OBi110 Administration Manual page 100

X_InboundCallRoute
X_RegisterEnable
X_KeepAliveEnable
X_KeepAliveExpires
X_KeepAliveServer
X_KeepAliveServerPort
X_KeepAliveMsgType
X_UserAgentPort
DirectoryNumber
X_DefaultRing
X_CallOnHoldRing
X_RepeatDialRing
X_BargeInRing
X_CallParkedRing
X_SIPDebugOption
Routing rule for directing incoming calls on this service. The
default rule is to send all incoming calls to the PHONE port (ph).
See OBi Call Routing and Digit Map Section for a description of
the syntaxes for specifying this parameter
Enable registration for this line. If set to YES, device sends
periodic SIP REGISTER to the service provider according to the
settings in the ITSP Profile. Otherwise, device does not send any
SIP REGISTER for the service
Enable sending keep alive message. If set to YES, device sends
periodic keep-alive messages to the destination specified in
X_KeepAliveServer and X_KeepAliveServerPort, at the interval
specified in X_KeepAliveExpires. The content of this message is
the ASCII string "keep-alive\r\n"
Keep alive period in seconds
Hostname or IP address of keep alive server
UDP port of the keep alive server
The type of keep alive messages to send out periodically if keep-
alive is enabled. It can be one of the following choices:
- keep-alive: The string "keep-alive"
- empty: A blank line
- stun: A standard STUN binding request; device will use the
binding response to form its contact address for
REGISTRATION
UDP port where the device sends and listens for SIP messages
Directory number associated with this service
Default ring pattern number to ring the PHONE port for incoming
calls on this trunk that are routed to the PHONE port according
to the InboundCallRoute of this service. The ring pattern is taken
from the selected Ring Profile. Valid choices are 1-10
Pattern to ring PHONE port when holding a call on this trunk that
has been connected to the PHONE port. Typically this is a very
short distinctive ring pattern that serves as a reminder to the
user that a call is being on hold. The ring pattern is taken from
the selected Ring Profile. Valid choices are: NO Ring, or 1-10
The ring pattern number to use to ring the PHONE port when a
repeat dial operation on this trunk is successful as the called
party is either ringing or answered
Call Waiting Ring pattern to ring the PHONE port when the
incoming call is requesting to barge-in. This is applicable in a
call-waiting scenario on the PHONE port
Ring pattern to ring the PHONE port only as a reminder that
there are some calls parked in the parking lot. This feature is
applicable only in an OBiPLUS solution.
Enable sending of SIP signaling debug information to the syslog
server (if one is configured on the device). Available choices are:
Disable (do not send SIP signaling debug information)
Copyright 2010-2012 Obihai Technology, Inc.
ph
Yes
No
15
5060
keep-alive
5060
1
8
5
4
10
Disable
100