User Defined Digit Maps; A User Defined Digit Map For Ipv4 Dialing - Obihai OBi110 Administration Manual

si1 – si4 = SIT TONE 1 – 4, respectively
st = Stutter Tone
0 – 9, *, #, a – d = DTMF 0 – 9, *, #, A – D respectively

User Defined Digit Maps

Starting from release 1.2, there are 10 user definable digit maps available under the User Settings – User Defined Digit
Maps section of the device configuration web page. These digit maps are referred to as User Defined Digit Map 1 to 10.
Each user defined digit map is specified with 2 parameters:
- Label: An arbitrary string for referencing this digit map in other digit map specification. The value should be 2-16
characters long. For example, "friends". In this case, (Mfriends) can be referenced in other digit maps, such as
PHONE Port::DigitMap
- DigitMap
By default both parameters are empty, except for User Defined Digit Map 1 (see the section below).

A User Defined Digit Map For IPv4 Dialing

The default values of the parameters for User Defined Digit Map 1 are set the following values to support IPv4 Dialing:
- Label: ipd
- Digit Map: (xx.<*:@>xx?x?<*:.>xx?x?<*:.>xx?x?<*:.>xx?x?|
xx.<*:@>xx?x?<*:.>xx?x?<*:.>xx?x?<*:.>xx?x?<*::>xx?x?x?x?)
The map (Mipd) is referenced in the default setting of the DigitMap in ITSP Profile A and B. It supports the following two
forms of IPv4 dialing:
a) <user-id>*<a>*<b>*<c>*<d>
b) <user-id>*<a>*<b>*<c>*<d>*<port>
where <user-id> is an arbitrary length numeric user-id, such as 100345, <port> is a port number in the range 0–65535, and
each of <a>,<b>,<c>,<d> is a 1-3 digit pattern in the range 1–255 that identifies one byte of an IP address. The dialed
number will be translated into <user-id>@<a>.<b>.<c>.<d> and <user-id>@<a>.<b>.<c>.<d>:<port> respectively. Here are
some examples:
1234*192*168*15*113
123456*192*168*15*180*5061
maps to 1234@192.168.15.113
maps to 123456@192.168.15.180:5061
Copyright 2010-2012 Obihai Technology, Inc. 185