Chapter 14. Advanced Applications
Example of Multi-Effects Settings
Producing a Muffled Tonal Character
By severely cutting the mid-range and boosting the
low range, you can simulate a muffled sound, as if it
were heard from the next room.
Apply to parts: all parts
fig.14-19
Using Spectrum to Create a Lo-Fi
Sound
In the opposite of the previous example, here we cut
the high and low range and boost only the mid-range.
This is effective when applied to rhythm or bass. You
can also accentuate the effect by using the part mixer
Key Shift to slightly lower the pitch of the rhythm
part.
Apply to parts: all parts
fig.14-20
14
180
SPECTRUM
MULTI CTRL1
Low-High Gain
MULTI CTRL 2
Middle Gain
MULTI CTRL3
Output Level
SPECTRUM
MULTI CTRL1
Low-High Gain
MULTI CTRL 2
Middle Gain
MULTI CTRL3
Output Level
Hardening the Overall Character
Use an Enhancer to sharpen the definition of the
sound, bringing it to the front. This is effective when
applied to brass-type sounds or piano-type sounds.
Apply to parts: all parts
fig.14-21
Distorted TB-303 Type Sounds
This is effective when applied to a patch such as
P:A18.
fig.14-22
ENHANCER
MULTI CTRL1
Sens
MULTI CTRL 2
Mix Level
MULTI CTRL3
Output Level
OVERDRIVE
MULTI CTRL1
Drive
MULTI CTRL 2
AMP Type
MULTI CTRL3
Output Level