Roland JX-305 Owner's Manual page 123

Reverb (Add Reverberation)
This effect adds reverberation and ambiance to the
sound, creating spatial depth.
fig.7-52 (#MC fig.4-63)
Rev Type (Reverb Type)
You can select one of the following six basic types of
reverb.
Available Settings:
ROOM1: Reverb with short decay and high density.
ROOM2: Reverb with short decay and low density.
STAGE1: Reverb with much subsequent reverber-
tion.
STAGE2: Reverb with strong early reflections.
HALL1: Clear-sounding reverb.
HALL2: Rich-sounding reverb.
Time (Reverb Time)
Specifies the duration of the reverberation.
Range: 0–127
HF Damp
Determines the frequency at which the high frequency
portions of the reverberation will be cut.
Range: 200–8000 (Hz), BYPASS
As this parameter is set to a lower frequency, more of
the high range will be cut, making the reverberation
more muted in tone.
If you do not wish to cut the high frequency range,
select "BYPASS."
Balance (Effect Balance)
Specifies the volume balance between the original
sound and the reverberation.
Range: D100:0E–D0:100E
With a setting of "D100:0E" no reverb sound will be
output.
REVERB
MULTI CTRL1
Time
MULTI CTRL 2
Balance
MULTI CTRL3
Output Level
[MULTI CTRL 1]
[MULTI CTRL 2]
Chapter 7. Applying Effects to the Sound (Effects)
Output Level
[MULTI CTRL 3]
Specifies the output volume from the reverb effect.
Range: 0–127
Gated Reverb (Sharply Cut the
Reverberation)
This is a type of reverb, in which the reverberation is
cut off before the natural completion of its decay.
fig.7-53 (#MC fig.4-64)
Gate Type (Gate Reverb Type)
Select one of the following four basic types of gated
reverb.
Available Settings:
NORMAL: Normal gated reverb
REVRSE: Reverse-playback reverb
SWEEP1: The reverberation will sweep from right
to left.
SWEEP2: The reverberation will sweep from left to
right.
Gate Time (Gate Reverb Time)
[MULTI CTRL 1]
Specifies the time from when the reverberation begins
until it ends.
Range: 5–330
Balance (Effect Balance)
Specifies the volume balance between the original
sound and the reverberation.
Range: D100:0E–D0:100E
With a setting of "D100:0E" no reverberation will be
output.
Output Level
[MULTI CTRL 3]
Specifies the output volume of the Gate Reverb effect.
Range: 0–127
GATE-REVRB
MULTI CTRL1
Gate Time
MULTI CTRL 2
Balance
MULTI CTRL3
Output Level
[MULTI CTRL 2]
123
7