Copying And Initializing Settings - Roland JX-305 Owner's Manual

At this time, you can press [UNDO/REDO] to check
the name of the pattern that is currently in the save
destination number. After you have found a pattern
that you do not mind overwriting, press
[UNDO/REDO] once again to return to the previous
display.
6. Press PAGE [>].
The cursor will move to the beginning of the second
line of the display.
fig.3-34
7. Assign a name to the pattern.
Use [INC] [DEC] or the [VALUE] dial to select charac-
ters.
The following characters are available.
space, A–Z, a–z, 0–9, ! " # $ % & ' ( ) * +, - . / : ; < = > ?
@ [ ¥ ] ^ _ ` {|}
8. Repeat steps 6–7 to input the name.
You can move the cursor back toward the left by
pressing PAGE [<].
9. Press [ENTER].
The confirmation screen will appear in the display.
If you decide to cancel the operation, press [EXIT].
fig.3-35
10. Press [ENTER] once again.
fig.0-5
The Pattern Write operation will be carried out, then
the normal display will reappear.
The pattern has now been saved.
On the JX-305, the following parameters are memo-
rized for each pattern.
Standard Tempo (p. 31)
Patch Number * (p. 18)
Part Level * (p. 33)
Part Pan * (p. 33)
Part Key Shift * (p. 34)
Part Reverb Level * (p. 34)
Part Delay Level * (p. 34)
Part Multi-Effects Switch * (p. 34)
Reverb settings # (p. 102)
Delay settings # (p. 103)
Chapter 3. Playing Patterns
Multi Effects settings (p. 106)
Part Mute status * (p. 32)
Rhythm Mute status (p. 32)
Sequencer Output Assign * (p. 36)
Key Mode # (p. 18)
Split Point # (p. 20)
Part number assigned to the upper part # (p. 20)
Part number assigned to the lower part # (p. 20)
* The "*" indicates parameters that are set independently
for each part.
* If you switch patterns while playback is stopped, "#" set-
tings will be updated. However, if you switch patterns
during playback, These parameters will maintain the set-
ting of the previous pattern.
These parameters are collectively referred to as the
"setup parameters."

Copying and Initializing Settings

Setup Copy
This operation copies the setup parameters of a speci-
fied pattern to the temporary pattern.
1. Press [PTN/SONG] to access the pattern
select page.
2. Press [UTILITY].
The indicator will light.
3. Press PAGE [<] [>] several times to select
"COPY," and press [ENTER].
4. Press PAGE [<] [>] several times to select
"SETUP PARAM," and press [ENTER].
The display will indicate the copy source pattern, copy
source part, and copy destination part.
fig.3-37
5. Use [INC] [DEC] or the [VALUE] dial to speci-
fy the copy source pattern, the copy source
part, and the copy destination part.
You can move the cursor by pressing PAGE [<] [>].
Available settings for the part:
P1–P7, R: Setup parameters of the specified part
FX: Effects setup parameters
ALL: All setup parameters
If the copy source part setting is "R," "FX" or "ALL,"
it will not be possible to specify the copy destination
part.
6. Press [ENTER].
The confirmation screen will appear in the display.
If you decide to cancel the operation, press [EXIT].
fig.3-38
3
37