Saving Rhythm Sets You've Created (Rhythm Set Write) - Roland JX-305 Owner's Manual

Chapter 6. Creating an Original Rhythm Set (Rhythm Edit)
R.TONE Dly Level (Rhythm Tone Delay Level)
Specifies the amount of delay for each rhythm tone.
Range: 0–127
Higher settings will increase the delay volume.
* The Rhythm Tone Delay Level setting is valid only when
the Part Multi-Effects Switch setting of the rhythm part
is set to "RHY." Also in this case, if the Delay Level and
the Part Delay Level setting of the rhythm part are low,
there will be no delay even if the Rhythm Tone Delay
Level is raised.
"Specifying the Part(s) to Which Multi-Effects
Will Be Applied (Part Multi-Effects Switch)" (p.
124)
"Adjusting the Overall Delay Volume
(Delay Level)" (p. 104)
"Adjusting the Delay Volume for Each Part
(Part Delay Level)" (p. 104)
If you would like to know more about delay
settings...
"Adding an Echo to the Sound (Delay)" (p.
103)
R.TONE M-FX SW (Rhythm Tone Multi-
6
Effects Switch)
This switches multi-effects on/off for each rhythm
tone. Make this setting when you wish to apply multi-
effects only to a specific rhythm tone.
Range:
OFF: Multi-effects will not be applied.
ON: Multi-effects will be applied.
* The setting of the Rhythm Tone Multi Effect Switch is
valid only when the Part Multi Effect Switch of the
rhythm part is set to "RHY."
"Specifying the Part(s) to Which Multi-Effects
Will Be Applied (Part Multi-Effects Switch)" (p.
124)
* If the Multi-Effects Output Level is set to a low value, the
rhythm tone to which multi-effects is applied will not be
heard.
If you would like to learn more about multi-
effects settings...
"Applying Various Effects to the Sound
(Multi-Effects)" (p. 106)
98
Saving Rhythm Sets You've
Created (Rhythm Set Write)
When you have created a rhythm set that you like, you
can save it as a User Rhythm Set.
1. Make sure that the pattern is stopped.
2. Press [PATCH] to access the rhythm set
select page.
When you modify the settings of a rhythm set, an
asterisk "*" will appear at the left of the number, indi-
cating that the selected rhythm set has been modified
(edited).
Be aware that if you select a different rhythm set with-
out saving the modified rhythm set, your changes will
be lost.
3. Hold down [SHIFT] and press [WRITE].
The indicator will blink.
The following display will appear, and the cursor "
will appear at the left of the number.
fig.6-31
SHIFT UTILITY
WRITE
If you do not wish to change the number or name, you
can omit steps 4–8.
If you decide not to save the rhythm set, press [EXIT].
4. Press [PRESET/USER/CARD] to select the
save destination group.
* It is not possible to select the PRESET group.
* CARD groups can be selected only if an optional memory
card is inserted.
"Using Memory Cards" (p. 159)
5. Use [INC] [DEC] or the [VALUE] dial to select
the save destination bank and number.
You can also use the BANK and NUMBER [1]–[8] but-
tons to select the save destination bunk and number.
"