Transposing The Pitch (Transpose); Modifying The Strength Of Notes (Change Velocity) - Roland JX-305 Owner's Manual

Chapter 9. Editing Patterns
10. Press [ENTER].
The confirmation screen will appear in the display.
fig.9-16 (#MC fig.11-14)
11. Press [ENTER] once again.
The Erase operation will be carried out, and the nor-
mal display will reappear.

Transposing the Pitch (Transpose)

This operation shifts the note numbers (pitch) of the
data recorded in a pattern. You can specify a transpo-
sition of up to +/-2 octaves.
* It is not possible to specify the range of measures that will
be transposed.
fig.9-25TEXT (=MC fig.11-23)
Transpose 4 semitones upward (+4)
1. Select the pattern that you wish to trans-
pose.
2. Press [EDIT].
The indicator will light, and the edit page will appear
in the display.
3. Press NUMBER [5] (TRANSPOSE).
9
The display will show the Transpose setting page.
fig.9-26 (#MC fig.11-24)
EDIT
FX ON/OFF
4. Select the part that you wish to transpose.
* You can select more than one part.
5. Specify the amount of transposition, in
semitone steps.
Range: -24–+24
* If the setting value is "0," no transposition will occur.
* If you apply Transpose to the Rhythm part, the sound will be
exchanged for different rhythm tones. In some cases, notes
may fail to sound.
142
5
CYM
TRANSPOSE
If you wish to transpose only a specific range of notes,
press the keyboard to specify the desired range. If you
do not specify the note range, all notes will be trans-
posed.
fig.9-27
D4 G4
6. Press [ENTER].
The confirmation screen will appear in the display.
fig.9-28 (#MC fig.11-25)
7. Press [ENTER] once again.
The Transpose operation will be carried out, and the
normal display will reappear.
Modifying the Strength of Notes
(Change Velocity)
This operation modifies the velocity (playing strength)
of the notes recorded in the pattern. Increasing the
velocity values will cause the notes to be played more
strongly. This operation can be used to increase or
decrease the overall keyboard playing dynamics.
* If this operation would result in a velocity greater than 127
(or less than 1), the result will be limited to 127 (or 1).
* It is not possible to specify the range of measures in which
velocity will be modified.
fig.9-29TEXT (=MC fig.11-26)
100 90 100 80
Reduce velocity
values by 15
85 75 85
65
1. Select the pattern in which you wish to
modify the velocity.
2. Press [EDIT].
The indicator will light, and the edit page will appear
in the display.
3. Press NUMBER [6] (CHG EVENT) to select
the "CHG VELO" setting page.
fig.9-31 (#MC fig.11-27)
Increase velocity
values by 10
110 100 110 90