Saving Patches You've Created (Patch Write) - Roland JX-305 Owner's Manual

Chapter 5. Creating Original Sounds (Patch Edit)
Velo Range (Velocity Range Switch)
Specifies whether or not the Velocity Range settings
will be enabled. By using velocity range settings, you
can cause different tones to sound in response to notes
played at different strengths on the keyboard.
Range: OFF, ON
When this setting is "ON," the Velocity Range settings
will be used.
If you wish to change the loudness of the notes
played on the keyboard...
"Changing the Loudness of Notes Played on
the Keyboard (Keyboard Velocity)" (p. 163)
Velo Range L (Velocity Range Lower)
Specifies the lower velocity limit for which the tone
will sound.
The tone will not be sounded by notes played with a
velocity lower than this setting.
Range: 1–UPR
5
Velo Range U (Velocity Range Upper)
Specifies the upper velocity limit for which the tone
will sound.
The tone will not be sounded by notes played with a
velocity stronger than this setting.
Range: LWR–127
fig.5-77TEXT (=MC fig.3-72)
Level
127
80
64
0
T1 T2
T1 T2
Velo Range U 127 80
Velo Range L 64
* It is not possible to set the Lower value above the Upper,
or the Upper below the Lower.
Velo X-Fade (Velocity Crossfade)
Specifies the way in which the volume will change
when a keyboard is played with a velocity that falls
outside the velocity range setting.
Range: 0–127
Higher settings will cause the volume to decrease
more gradually when the velocity falls outside of the
velocity range.
82
Tone which will sound
T1
Velocity=115
T1 T2
Velocity=70
T2
Velocity=30
Velocity
T3
T3
127
0 0
By using Velocity Crossfade, you can use playing
dynamics on the keyboard to smoothly connect two
tones.
fig.5-78TEXT (=MC fig.3-73)
Level
TONE1
Saving Patches You've
Created (Patch Write)
After you've created a patch you like, do this to save it
as a User Patch:
1. Make sure the pattern is stopped.
2. Press [PATCH] to access the Patch Select
page.
If you've modified the patch settings, an asterisk "*"
will be displayed at the left of the number, indicating
that the selected patch has been modified (edited).
Be aware that if you select a different patch without
saving the modified patch, your changes will be lost.
3. Hold down [SHIFT] and press [WRITE].
The indicator will blink.
T3
The following display will appear, and the "
sor) will appear at the left of the group.
T3
fig.5-84
SHIFT
T3
If you do not wish to change the number or name, you
can omit steps 4–8.
If you decide not to save the patch, press [EXIT].
4. Press [PRESET/USER/CARD] to select the
save destination group.
* It is not possible to select the PRESET group.
* CARD groups can be selected only if an optional memory
card is inserted.
"Using Memory Cards" (p. 159)
Velo X-Fade
Velo Range U
Velo Range L
TONE2
A-ENV
Velo Sens
Velocity
40 60
UTILITY
WRITE
T1 T2
30 30
40 127
0 60
0 0
" (cur-