Troubleshooting The Finisher - Riso ComColor 9050 Troubleshooting Manual

Troubleshooting the Finisher

This section describes how to troubleshoot problems related to the finisher.
Problem
The finisher does not operate.
In copy mode, the paper is stapled at the
wrong position.
Staples are bent, flattened, or otherwise not
inserted correctly.
A staple is caught inside the machine.
Possible Cause and Action to Take
Make sure that the power plug has been properly inserted into the
electrical outlet.
Make sure that the printer and finisher have been securely connected by
the cord.
Make sure that the main power of the printer is on.
Turn the printer off and then on again. If the finisher still does not
operate, contact your dealer (or authorized service representative).
The orientation of the loaded original does not match the [Original
orientation] setting on the [Staple/Punch] screen.
Align the orientation of the original with the [Original orientation] setting
on the [Staple/Punch] screen.
⇒ Copy mode screen
[Functions]
set [Original orientation]
[Auto-Rotate] has not been set to [ON].
When [Auto-Rotate] has not been set to [ON], the machine cannot staple
or punch the paper at the correct position. Set to [ON].
⇒ Copy mode screen
[Functions]
There are too many pages for stapling.
The number of pages that can be stapled are as follows: 100 for 85 g/m
A4 (Letter) or smaller paper, and 65 for paper larger than A4 (Letter).
If staples have not been inserted correctly even within the above range of
pages for stapling, contact your dealer (or authorized service
representative).
Follow the instructions for removing the staple in "A staple is Caught
Inside the Machine" (p. 2-18).
[Staple/Punch]
[Auto-Rotate]
ComColor Series Troubleshooting Guide 01
2
2
2-17