Kyocera ECOSYS M3540idn Operation Manual page 45

Sending Faxes > Methods For Entering the Destination
3
4
Select transmission settings.
1
It is possible to change the transmission settings by pressing [On Hook], [Sub Address] or
[Detail Settings].
Key
On Hook
Sub Address
Detail Settings TX Start Speed
ECM
Encrypted
Transmission
Press [OK].
Entry of the destination finishes.
NOTE
When On is selected in Entry Check for New Dest., a confirmation screen is displayed for
the entered FAX number. Re-enter the same FAX number and press [OK]. For details, refer
to Entry Check for New Dest. in the Operation Guide for the machine.
Press [Next Dest.] to enter the next fax number.
For details, refer to Broadcast Transmission on page
In addition to a fax, you can include e-mail transmission and folder (SMB/FTP) transmission
to send as one job. For details, refer to the machine's Operation Guide.
Press [On Hook] to connect to the telephone line.
When the FAX number has been entered, the machine starts
dialing to the receiving system.
After pressing this key, you can dial the number of the
receiving system using the numeric keys. For details, refer to
Manual Send on page
Set this to transmit using a Sub Address. For details, refer to
Sub Address Transmission on page
This is set to change the transmission start speed. Select the
speed from 33,600 bps, 14,400 bps, and 9,600 bps.
NOTE
Normally this should be used with the default setting.
ECM is a communication mode specified by the ITU-T
(International Telecommunication Union) that retransmits data
when an error occurs. Fax machines that have ECM mode
check for errors as they communicate, preventing distortion of
the image due to noise on the line and other conditions.
This is set when using encrypted transmission to send the
data. For details, refer to
3-14.
3-9
Description
3-22.
5-16.
Encryption on page 5-25.