Using The Autopilot; Safe Operation With The Autopilot; Activating The Autopilot - B&G ZEUS Touch Operator's Manual

6
See "The Autopilot
settings panel" on page 44
for further information

Using the Autopilot

If an Autopilot computer is connected to the system, Autopilot functionality will be available
in the Zeus Touch.
An Autopilot is designed to maintain an accurate course in various sea conditions with
minimal helm movements.

Safe operation with the Autopilot

Warning: An Autopilot is a useful navigational aid, but DOES NOT
under any circumstances replace a human navigator.
Switching from automatic mode to manual steering
You can switch the Autopilot to STBY mode from any automatic operation mode by a short
press on the STBY/AUTO key.
¼ Note:
If the Zeus Touch is connected to an EVC system via the SG05, you can take manual
control of the steering irrespective of the Autopilot mode. Refer "Using the Autopilot in an
EVC system" on page 43.

Activating the Autopilot

You can activate the Autopilot from any panel as shown below.
The Autopilot pop up
You can only enable the Autopilot once the pop-up is displayed.
anual adjustments to the set heading can only be made when the
port and starboard indicators are illuminated red and green - this is
done by pressing the rotary knob, or by tapping the Autopilot pop-
up.
The Autopilot popup shows active mode, heading, rudder and
various steering information depending on active Autopilot mode.
The pop-up has a fixed position on the page, and it can be shown on all pages except when
an Autopilot panel is active.
You remove the pop-up from a page by tapping the
pressing the X key.
Autopilot mode indication in top of the page
Autopilot information is by default shown in top of the pages when the Autopilot pop-up is
not displayed.
You can select to turn this information off.
Using the Autopilot | Zeus Touch Operator Manual
STBY
AUTO
in the upper right corner or by
| 33