Setting Up The Sonichub Speakers; Operating The Audio Source - B&G ZEUS Touch Operator's Manual

78 |

Setting up the SonicHub speakers

Speaker zones
Your unit has four on-board amplified channels for directly driving speakers. There are also
two low level channels (stereo) for supplying signal to an external amplifier, plus two mono
channels for amplified subwoofer(s).
The audio outputs are organized in 3 zones. You can adjust balance, volume and volume limit
settings independently for each zone. Adjustments to the bass and treble settings will alter all
zones. Refer graphics.
Zone 1 Left/Right speakers
Zone 2 Left/Right speakers
Zone 3 Amplifier output, Subwoofer output
Master volume control
By default the volume for all speaker zones are adjusted when you adjust the volume on an
Zeus Touch unit.
You can adjust each speaker zone individually from any Zeus Touch unit from the SonicHub
Zones dialog. From this dialog you can also define which zones that shall be altered when you
increase/decrease the volume from the control unit.

Operating the audio source

Selecting the audio source
You switch between available audio sources from the audio menu.
¼ Note:
The Mic source selects a high voltage level input allowing you to broadcast loud hailer
messages over the audio system.
Adjusting the volume
The volume is adjusted by using the rotary knob, pressing the IN / OUT key
or by tapping the volume level icon and then dragging your finger on the
slide bar.
The volume can also be adjusted by using the menu, and from the master control dialog as
described later in this chapter.
Muting
You toggle muting on/off by pressing the rotary knob.
Audio | Zeus Touch Operator Manual
MARK
MENU