Placing The Cursor; Positioning A Man Over Board Mark; Screen Capture - B&G ZEUS Touch Operator's Manual

Placing the cursor

The cursor is by default not shown on any panel.
You tap the screen to place the cursor on a Chart, Radar,
StructureScan or Echosounder panel. The cursor information
window will show position coordinates at the cursor position,
and range and bearing to the vessel.
On an Echosounder panel, the cursor information window will include the depth at cursor
position.
Further use of the cursor is described in the Chart, Radar and Echosounder sections.
To remove the cursor and cursor window from the panel, press the X key or tap the
cursor

Positioning a Man Over Board mark

If an emergency man over board situation should occur, you can position a Man Over Board
mark at the vessel's current position by pressing the two MOB keys simultaneously.
When you activate the MOB function the following actions are automatically performed:
• a MOB mark is positioned at the vessel's position
• the display switches to a zoomed chart panel, centered on vessel position
• the Zeus Touch creates an active route to the MOB mark
IN
MOB
Cancel navigation
The Zeus Touch will continue navigating towards the MOB point until the waypoint is reached
or until you select to stop this navigation.
Positioning multiple Man Over Board marks
Once the MOB function has been initialized, pressing the MOB keys again will place a new
MOB waypoint on the chart. Continued presses of the MOB keys will place more MOB
waypoints.
¼ Note:
waypoint is reached, or until you stop the navigation. Navigation to subsequent MOB marks
will need to be done manually. (See navigating on the chart section for more details).
Delete a MOB mark
A MOB mark is deleted by selecting the MOB mark and then activating the menu.
A MOB can also be deleted as described in page 23 .
STBY
AUTO

Screen capture

Simultaneously press and hold the GOTO/PAGES and power keys to take a screenshot.
MARK GOTO
MENU PAGES
By default, screen captures are saved to internal memory. From the internal memory they can
IN OUT be copied to another folder or Micro-SD card via the Files menu.
MOB MOB
Basic operation |
panel button.
OUT
MOB
+
The vessel will always continue to navigate towards the initial MOB mark until the
Zeus Touch Operator Manual
Clear
| 13