Table of Contents
Advertisement
Power On / Reset Counts
Note: Power On / Reset Counts is a read-only command.
Power-On
Serial Cmd:
<K406,power-on,resets,power-on saves,power-on flash saves,power-on
tube/cap library saves>
Power-On uses a 16-bit counter that increments each time the imager is powered-on.
Resets
Serial Cmd:
<K406,power-on,resets,power-on saves,power-on flash saves,power-on
tube/cap library saves>
Resets uses a 16-bit counter that increments each time the imager is reset. This value is
reset at power-on.
Power-On Saves
Serial Cmd:
<K406,power-on,resets,power-on
tube/cap library saves>
Power-On Saves uses a 16-bit counter that increments each time an imager setting is
saved for power-on with a
Power-On Flash Saves
Serial Cmd:
<K406,power-on,resets,power-on
tube/cap library saves>
Power-On Flash Saves uses a 16-bit counter that increments each time an imager setting
is saved to the customer parameter section of flash memory with a
Power-On Tube/Cap Library Saves
Serial Cmd:
<K406,power-on,resets,power-on saves,power-on flash
tube/cap library
Power-On Tube/Cap Library Saves uses a 16-bit counter that increments each time an
imager setting is saved to the Tube/Cap Library parameter section of flash memory with
a
<Z1>
command.
EZ Match User's Manual
<Z>
command.
saves>
saves,power-on flash saves,power-on
saves,power-on flash
<Zc>
I/O Parameters
saves,power-on
command.
saves,power-on
8-53
Advertisement
Table of Contents
Need help?
Do you have a question about the EZ Match Imager and is the answer not in the manual?