Change User Code (Master User Only); Activating Pgm From The Keypad (Master User Only) - Pyronix MATRIX 6 User Manual

Matrix 6/816 User Manual

4.9 Change User Code (Master User Only)

Press `25
Enter the user to be edited....
If you wish to change the user
code, enter the new code twice. If
you wish to edit the user
attributes only, enter the current
code twice.*
Use the [ and ] keys to
select the option you wish to edit,
or select it directly using the
numeric keys
Toggle the option on or off using
the - key. If the option is on,
the k icon is visible. If the option
is off, the k icon is not visible.
Repeat for all options as required
Press ` to save the changes
...NOTE: To delete an existing user code and return to the user menu, press [ after entering the
user number.
*NOTE: For four- and five-digit user codes, you must press ` after entering the code to proceed.
For a six-digit code, the code is accepted automatically.
? option: User Code Attributes
1 Omit (Bypass) Zones
2 Duress Code Only
3 Duress Enabled

4.10 Activating PGM from the Keypad (Master User Only)

Press `27
Page 16
The panel requests a user number.
Example shows User 2.
The system shows attribute option 1.
Example shows option 3.
Example shows option 3 off.
Any PGM output programmed as "RKP
Controlled" will switch on for 15
seconds. Which PGM output is
controlled by the keypad is
determined by your engineer.
OFF
Disable
[Disable]
[Off]
[default]
ON
[Enable]
Enable
On
RINS545-7