Copying Problems - Toshiba e-studio 2555c Troubleshooting Manual

2 TROUBLESHOOTING FOR COPYING

Copying Problems

See the table below when you have a problem in operating copy function or have an unexpected copy output.
Problem Description
Functions cannot be set.
Copying stops during
scanning of the originals.
(The message "The
number of originals
exceeds the limits Will
you print out stored
originals?" appears.)
Copying stops during
scanning of the originals.
(The message "Not
enough Work Space to
store originals Will you
print out stored originals?"
appears.)
Copied image is too light.
Copied image is too dark.
Copied image has stains.
Copied image has stains.
74 Copying Problems
Cause
Another function that is
unavailable for the
combination has already been
set.
The number of scanned
pages has reached the
maximum.
No available internal memory
remains.
No toner is left.
Copy density is set too light.
Copy density is set too dark.
The Original Cover or the
Reversing Automatic
Document Feeder is not fully
lowered.
The original glass, platen
sheet, scanning area and
guide are stained.
The copy density is set too
dark.
A transparent original such as
a transparency or tracing
paper is being used.
The separation fingers in the
fuser unit are dirty.
Corrective Action
Some functions cannot be combined.
For details, refer to Chapter 8 of the Copying
Guide.
To copy the scanned images, press [YES]. To
cancel, press [NO].
To copy the scanned images, press [YES]. To
cancel, press [NO].
The message "Install new Black (Cyan,
Magenta or Yellow) cartridge" appears when
no toner is left. Replace the toner cartridge of
the color the message indicates.
P.52 "Replacing a Toner Cartridge"
Darken the density manually or try the
automatic density mode.
Lighten the density manually or try the
automatic density mode.
Lower it fully to block outside light.
Clean them.
P.129 "Regular Maintenance"
Lighten the density manually or try the
automatic density mode.
To copy a transparent original clearly, put a
sheet of blank, white paper behind the original.
Make sure that the paper is large enough to
cover the original.
When paper is placed on the bypass tray to
make copies, set its size.