Toshiba e-studio 2555c Troubleshooting Manual page 77

Problem Description
Copy image is skewed.
Copied image is partially
missing.
Copied image is blurred.
Copied image has
unevenness in the
horizontal direction.
Cause
The original is sent from the
Reversing Automatic
Document Feeder at a skew.
The gap between the paper
and the side guides in the
drawer or the bypass tray is
too large.
The size or orientation of the
copy paper and that of the
original are not consistent.
The reduction ratio is not
properly set.
The binding margin is too
wide.
The original is larger than the
printable area.
There is a gap between the
original glass and the original.
The copy paper is damp.
The main charger is stained.
2 TROUBLESHOOTING FOR COPYING
Corrective Action
Replace the original while aligning the side
guides of the Reversing Automatic Document
Feeder to its width so that it will be placed
straight.
Adjust the gap between the paper and the side
guides so that it becomes appropriate.
For details, refer to Chapter 1 and 2 of the
Copying Guide.
Fit the copy paper size to the original or set
the reduction ratio for the copy paper.
Set the binding margin width to fully cover the
original.
For details, refer to Chapter 4 of the Copying
Guide.
The outside part of the printable area cannot
be copied. The Full Image function enables
you to copy the whole image of the original in
the 95 - 99% reduction ratio.
Lower the Original Cover or the Reversing
Automatic Document Feeder fully so that the
original fully contacts the platen glass.
Replace it with dry copy paper.
Clean the main charger.
P.67 "Cleaning the Main Chargers and LED
Print Heads"
Copying Problems 75