Mitsubishi Electric Mr.Slim PAR-30MAA Technical Manual page 75

Route the wire to the top case.
Connect the connector on the bottom case to the connector on the top case.
Securely connect the
connectors.
«Important»
To prevent malfunctions, do not remove the protective film
or the circuit board from the casing.
Route the wire to the top case.
«Important»
Hold the cables in place with clamps to prevent undue
force from being applied to the terminal block and causing
cable breakage.
Install the front cover and top case on the bottom case.
Two mounting tabs are at the top of the top case. (A cover is already installed on the case at the time of factory shipment.)
Hook those two tabs onto the bottom case, and click the top case into place. Check that the case is securely installed and
not lifted.
«Important»
When attaching the cover and the top casing to the bottom
casing, push it until it they click into place.
If they are not properly locked into place, they may fall,
causing personal injury, controller damage, or malfunctions.
■ Direct wall installation (when running the cable along the wall)
• Thread the cable through the access hole at the top of the
remote controller.
• Seal the cut-out part of the cover with putty.
• Use a cable cover.
Installation is complete.
Follow the instructions below when uninstalling them.
To prevent cable breakage and malfunctions, do not hang
the top controller casing hang by the cable.
Insert the wire.
Seal the gap with putty.
Clamp
Wall
No lifting
Use a cable cover.
Thread the cable through the
top of the remote controller.
75