View Details - Avaya IP Office H.323 Telephone Installation Manual

3.2 View Details

You can use the following procedure to view a number of phone details. These are in addition to the other static address
and local administration options which can also be used to review settings.
1600, 4600 and 5600 Series Phones
1. While the phone is on-hook and idle, press the following sequence: MUTE 8 4 3 9 # (MUTE V I E W #).
· To display the details, press * at any time during viewing.
· To end the procedure and restore the user interface to its previous state, press #.
2. A sequence of values are displayed. The values available vary between phone models and the level of IP phone
software installed on the phone. To display the next value press *. To exit the information display press #.
· Model - Shows the phones model number; for example, 4624D02A.
· Market - Shows 1 for export or 0 for domestic (US). Not displayed on all phone types.
· Phone SN - Shows the phone's Serial Number.
· PWB SN - Shows the phone's Printed Wiring Board Serial Number.
· PWB comcode - Shows the PWB's comcode.
· MAC address - Shows the phone's MAC address as paired hexadecimal numbers.
· L2 tagging - Indicates whether L2 tagging is on, off or set to auto.
· VLAN ID - The VLAN ID used for the phone. The default is 0.
· IP address - The IP address assigned to the phone.
· Subnet mask - The subnet mask assigned to the phone.
· Router - The router address assigned to the phone.
· File server - The address of the file server assigned to the phone.
· Call server - The address of the phone's H.323 Gatekeeper.
· 802.1X - The current setting for 802.1X operation if being used.
· Group - This displays the group value set on the phone. Group values can be used to control which options
(both firmware and settings) a phone downloads. Refer to the 4600 Series Phone LAN Administrator Guide.
· Protocol - Display Default.
· filename1 - Shows the name of the phone application file in the phone's memory. These are values from
within the boot file loaded and not the actual file name.
· 10MBps Ethernet or 100Mbps Ethernet - Shows the speed of the detected LAN connection.
· filename2 - Shows the boot file name and level. These are values from within the boot file loaded and not
the actual file name.
H.323 Telephone Installation
IP Office 15-601046 Issue 17e (Wednesday, November 14, 2012)
Page 68