Adjusting The Auto White Balance - JVC TK-C1530E Instructions Manual

Setup

Adjusting the auto white balance

Each light source has its own color temperature. Therefore, when the main
light source lighting an object is changed, press the SET button for a while and
adjust the white balance again.
CLASS 2 ONLY(U TYPE)
SEE INSTRUCTION
ISOLATED POWER ONLY(E TYPE)
MANUAL
POWER
+
DC12V INT LL
-
AC24V
RX TERM-OFF ON
MENU
SET
SET button
VIDEO OUT
SELECTOR
AWC OPERATION
Error display
AWC ERROR:NG OBJECT
Object error
AWC ERROR : HIGH LIGHT
Excessive Illumination
32
AWC OK
AWC ERROR : LOW LIGHT
Insufficient Illumination
1.
Place a white object at the center of the screen, under the same
lighting condition as the object to be shot and zoom in to fill the
screen with white.
2.
Press the SET button for approx. one second.
Auto white balance adjustment begins. During operation, AWC
OPERATION is displayed on the screen.
3.
Adjustment is complete.
When the appropriate white balance is acquired, AWC OK is displayed.
Error display
When auto white balance adjustment is not successful, the following
messages will be blinking on the monitor.
AWC ERROR : NG OBJECT (Object error)
Displayed when there is not enough white color on an object or the color
temperature is not suitable.
Shoot a white object to fill the screen thoroughly and adjust the white balance
again.
AWC ERROR : LOW LIGHT (Insufficient Illumination)
Displayed when the light is low. Increase the illumination, then readjust the
white balance.
AWC ERROR : HIGH LIGHT (Excessive Illumination)
Displayed when the light is too bright. Decrease the illumination, then readjust
the white balance.
33