Front Body Pillar (Cut - Toyota 1991 CAMRY Body Section Repair Manual

RE-16

FRONT BODY PILLAR (CUT)

REMOVAL
200 mm or move
Front Body Pillar Lower Gusset
1. Cut and join the new part at the location as
shown above.
NOTE:
1) Avoid the antenna installation hole for the
cut and join location.
2) As shown above, cut and join the front body
pillar outer and inner panels at a position
shifted above 50 mm (1.97 in.).
BODY PANEL REPLACEMENT
Cut and Join Location
Cut with a disc
sander etc.
3)
2.
[Cut and Join Location]
50 mm or
more
Make an incision
Roof Drip Channel
Before cutting, remove the antenna cord and
drain hole of the moonroof.
Remove the weld points of the roof drip channel,
make an incision of it and bend it.
mm in.
50 1.97
200 7.87