Table of Contents
Advertisement
INSTALLATION
Preparation for Supply Parts
Outer Pillar
Cutting Location
w/o
w/o
Automatic
Automatic
Shoulder
Shoulder
Belt
Belt
w/ Automatic
w/ Automatic
Shoulder Belt
Shoulder Belt
Upper Reinforcement
Door Lock Striker
Plate Retainer
[Preparation for supply parts]
1.
After installing the upper reinforcement to the
outer pillar, cut them at the location as shown
above.
[Installation]
1.
After temporarily installing the new part, check
fit for the front and rear door.
2.
After butt welding the new joint with a MIG
welder, sand the weld joint with a sander.
BODY PANEL REPLACEMENT
Butt Weld
about
15 mm
w/o Automatic Shoulder Belt
Upper Inner
Pillar
Wet Rag
Butt Weld
Braze
(front side and rear side)
w/ Automatic Shoulder Belt
mm
15
624
744
869
NOTE: Before performing these operations,
place a wet rag on the roof panel to protect it
from damage.
3.
Braze the roof side outer rail and center pillar
connection.
NOTE: Smooth down the surface.
Rail leakage will occur if the weather strip con-
tact is defective.
RE-19
Wet Rag
Upper Inner
Pillar
[REFERENCE]
in.
in.
mm
0.59
1,111
43.74
24.57
1,320
51.97
29.29
1,392
54.80
34.21
Hide quick links:
Advertisement
Table of Contents
