Toyota 1991 CAMRY Body Section Repair Manual page 55

INSTALLATION
Butt Weld
Body Sealer
about 5 mm
1. Before temporarily installing the new part, apply
body sealer to the wheel arch.
NOTE:
1) Apply sealer about 5 mm (0.20 in.) from the
flange, avoiding any oozing.
2) Apply evenly, about 3 - 4 mm (0.12 - 0.16 in.)
in diameter.
3) For other sealing points, refer to section AR.
BODY PANEL REPLACEMENT
Butt Weld
Body Sealer
2. Temporarily install the new part and check the fit
for the rear door, back door and rear combina-
tion light.
RE-37
Braze