Toyota 1991 CAMRY Body Section Repair Manual page 9

Proper and Efficient Work Procedures
REMOVAL
PRE-REMOV AL MEASURING
Before removal or cutting opera-
tions, take measurements in ac-
cordance with the dimension dia-
gram. Always use a puller to
straighten a damaged body or
frame.
PRECAUTIONS FOR DRILLING OR
CUTTING
Check behind any area to be drilled or
cut to insure that there are no hoses,
wires, etc., that may be damaged.
WRONG
INTRODUCTION
REMOVAL OF ADJACENT COMPONENTS
When removing adjacent components,
apply protective tape to the surrounding
body and your tools to prevent damage.
CAUTION:
1. Be especially careful not to damage
screw or clip holes.
2. If the paint is accidently scratched, ap-
ply touch-up paint immediately. Even
the slightest scratch may result in cor-
rosion or appearance of rust.
NO. OF SPOT WELDS
Make a note of the num-
ber of spot welds for lat-
er reference.
NOTE: The number of
spot welds may vary
depending on the
vehicle.
CUTTING AREA
Always cut in a straight
line and avoid reinforced
areas.
Cutting Okay
Corners
Reinforcement
IN-7