Toyota 1991 CAMRY Body Section Repair Manual page 51

INSTALLATION
Braze
Body Sealer
1. Before temporarily installing the new part,
coat the back side with body sealer.
NOTE:
1) Coat evenly about 10 mm (0.39 in.) from
the flange and 3 mm (0.12 in.) in diameter.
2) For other sealing points, refer to section
AR.
BODY PANEL REPLACEMENT
Assembly Mark
Body Sealer (3 points: W/ Rear Door Side Impact Protection Beam)
Braze
About 10 mm
30
2. Bend the flange hem about 30° with a hammer
and dolly. Then fasten tightly with a hemming
tool.
NOTE:
1) Performing hemming in three steps, being
careful not to warp the panel.
2) If hemming tool cannot be used, hem with a
hammer and dolly.
Body Sealer
Do not close the drain hole
Cloth Tape
°
Hemming Tool
mm
10
RE-33
in.
0.39